Replies
2
Voices
2

Categorized:
Tagged:

Peter Hamrak

Dear TC,

Two accepted ballot proposal is waiting for your wording approval.

Original:
A/ “ 16. Hull cross sections must be rectangular from a point 6’’ (153. mm) from the bow to a point 6’’ (153. mm) from the stern. A maximum 1/4’’ (6.3 mm) radius is allowed on the outside top corner of the fuselage where the deck and side panel intersect. Concavities in the deck are not permitted. “
Change to:
16.  Fuselage side panel parallel projected planes intersecting with deck or bottom parallel projected planes shall be approximately perpendicular to each other with an allowed deviation of about 2 degrees from a point 6’’ (153. mm) from the bow to a point 6’’ (153. mm) from the stern. A maximum 1/4’’ (6.3 mm) radius is allowed on the outside top corner of the fuselage where the deck and side panel intersect. Concavities in the deck are not permitted. “
And

Ammend:

  1. Fittings:

    18. The steering post head shall incorporate a safety feature to release the tiller upon the impact of the skipper’s body.

Could you please express your opinion about the wordings? It is quite urgent as it was due till the 1st of  September.
Thanks!

Peter